Chimney Work Made, Fitted and Serviced by One Team
Sri Vinayaga Chimney Work has been supplying, fabricating, installing and servicing commercial kitchen chimney and exhaust systems from Perundurai, Erode since 2017.
A Chimney Business That Starts at the Sheet Metal
Sri Vinayaga Chimney Work is a chimney and kitchen exhaust business based at Perundurai in Erode district, Tamil Nadu. We supply commercial kitchen chimneys, fabricate the hoods and ducting that go with them, install the complete system on site, and come back to service it.
Most of our work is for hotels, restaurants, bakeries, canteens and small industrial units — places where the exhaust runs hard every day and a weak system is felt immediately. Because we make the ducting ourselves, a difficult ceiling or an awkward discharge route gets solved at the fabrication stage rather than improvised on site.
The business has been operating since 2017, and the same team handles sales, manufacturing, fitting, installation and servicing.
Four Areas We Work In Every Week
Manufacturing Capability
Our workshop turns flat stainless steel and galvanised sheet into the parts a kitchen exhaust actually needs — canopy hoods, straight duct runs, radius elbows, square-to-round transitions, flanges and weather cowls. Everything is cut and formed to the measurements taken on your site.
- Hoods fabricated to kitchen dimensions
- Radius elbows and transitions formed in-house
- Stainless steel and galvanised sheet
- Replacement sections for existing systems
Fitting & Installation
On site we set out the duct route first, then mount the hood at the correct working height, fit and support the duct sections, seal the joints and install the blower or exhaust fan on a proper base. Discharge is terminated above roof level so the exhaust clears the building.
- Route planned before fabrication
- Hood height set to the cooking line
- Ducts supported off slab or wall
- Rooftop blower bases and discharge cowls
Servicing & Maintenance
Grease is what slowly closes a kitchen exhaust down. We clean hoods, baffle filters and duct runs, check the blower, belt and bearings, and restore suction across the cooking line. Servicing is available on systems installed by others as well.
- Hood, filter and duct cleaning
- Motor, belt and bearing checks
- Fault finding on weak suction
- Works on third-party installations
Custom & Industrial Work
Low slabs, shared walls, long external runs and multiple hoods on a single discharge are the jobs that standard products do not solve. These are measured, designed around the constraint, fabricated to suit and fitted as one system.
- Site survey and measurement
- Multi-hood single-discharge layouts
- External wall and roof duct runs
- Industrial exhaust and ventilation
Commitment to Quality
A chimney system is judged on one thing: does the kitchen stay clear when every burner is running. Everything we do is aimed at that — correct sizing, a duct route that does not fight the air, sealed joints, proper supports, and access left for cleaning.
- Measurements taken on site before anything is fabricated
- Material chosen for the duty of the run, not the lowest cost
- Joints sealed and sections supported so the run stays tight
- Filters, access panels and motors kept reachable for service
- Honest advice when an existing system needs redesigning, not patching
Looking for a Reliable Chimney Solution?
Talk to Sri Vinayaga Chimney Work about your chimney sales, manufacturing, fitting, installation or servicing requirement. Send us the details and we will get back to you.